Prediction Method of Curl in Fusing Process Considering Paper Properties

DOI

Bibliographic Information

Other Title
  • 紙質を考慮した定着過程のカール予測
  • シシツ オ コウリョ シタ テイチャク カテイ ノ カール ヨソク

Search this article

Abstract

<p>In electrophotographic printers and copiers, the fuser fixes resin particles for graphics on sheets by pressing and heating. It is known that curl is generated after the fusing process. One of the main factors of the curl generation is the temperature difference between paper surfaces due to the heating. In recent years, many brands of paper are import or recycling, so that large curl may occur sometimes. We start to develop a prediction method for curl by considering paper properties to describe the characteristics of paper. Permeability is the most influencing parameter of the curl, therefore the permeability was estimated by three methods and the amounts of curl were calculated for ten kinds of paper brands. It is found that the prediction of the curl is approximately corresponding with the experiment when the permeability is estimated from the porosity obtained by ash ratio of paper.</p>

Journal

Keywords

Details

  • CRID
    1390001204099161600
  • NII Article ID
    130006767900
  • NII Book ID
    AA1137305X
  • DOI
    10.11370/isj.56.145
  • ISSN
    18804675
    13444425
  • NDL BIB ID
    028157365
  • Text Lang
    ja
  • Data Source
    • JaLC
    • NDL
    • CiNii Articles
  • Abstract License Flag
    Disallowed

Report a problem

Back to top