微細エンドミル加工における<i>xy</i>平面内の切削負荷計測手法の開発

書誌事項

タイトル別名
  • Development of Cutting Force Measurement on <i>x</i>-<i>y</i> plane in Milling Operation with Micro End mill
  • Development of Cutting Force Measurement on x-y plane in Milling Operation with Micro End mill

抄録

Milling is one of the most important metal cutting processes. If the cutting force could be measured, we can make cutting process optimum, prevent tool breakage, and improve efficiency of process. Especially in the case of using a micro end mill, it is very difficult to identify whether cutting process is good or not.<br>In this paper, a cutting force measurement technique by using image processing was proposed. In the technique, we captured images of end mill by a small CCD camera and mirrors during cutting process from x and y direction to determine deflection of the tool and then estimated cutting force in x-y plane. Finally small cutting force was estimated accurately.

収録刊行物

  • 精密工学会誌

    精密工学会誌 81 (1), 86-90, 2015

    公益社団法人 精密工学会

参考文献 (1)*注記

もっと見る

詳細情報

  • CRID
    1390001204828171776
  • NII論文ID
    130004745514
  • DOI
    10.2493/jjspe.81.86
  • ISSN
    1882675X
    09120289
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ