書誌事項
- タイトル別名
-
- Measurement of Binder-Less cBN Tool Tip Temperature in End-Milling using Thermal Radiation Pyrometer Connected by Rotary Fiber Coupler
- ファイバ レンケツガタ ネツ ホウシャ オンドケイ ニ ヨル バインダレス cBN エンドミル カコウ オンド ノ ソクテイ
この論文をさがす
抄録
The temperature on the rake face of a binder-less cBN tool tip in end-milling was measured using a fiber-optic two-color pyrometer. The radiation of the interface between the tool tip and the chip is transmitted through the binder-less cBN and accepted by the optical fiber located behind the tool tip. The radiation accepted is transmitted to a two-color detector, which consists of a InAs and InSb detector, through a rotary fiber coupler. The coupler makes it possible to transmit the radiation outside the milling machine. The fundamental transmission characteristics of the coupler was investigated theoretically and experimentally. This method was found to be very practical to measure the tool tip temperature in end-milling. The results obtained are as follows. The rake face temperature in the up-milling of 0.55% carbon steel ranged from 480 degrees centigrade to 560 degrees centigrade for the cutting speeds of 2.2 m/s to 4.4 m/s. The cutting temperature increases with the increase of cutting speed. The temperature in down-milling is higher a little than that in the up-milling.
収録刊行物
-
- 精密工学会誌論文集
-
精密工学会誌論文集 71 (11), 1437-1441, 2005
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205280020480
-
- NII論文ID
- 10016764424
- 120005456145
-
- NII書誌ID
- AA11966630
-
- ISSN
- 18818722
- 13488716
- 13488724
-
- NDL書誌ID
- 7721191
-
- データソース種別
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可