-
- Deng Yong
- School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing
-
- Zhang Jian-liang
- School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing
-
- Jiao Ke-xin
- School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing
この論文をさがす
説明
<p>In order to investigate the dissolution mechanism of carbon brick into molten iron, cylindrical specimens were immersed into molten iron to carry out the experiments. The dissolution reaction of carbon was considered as the dominant reaction through thermodynamic analysis, the result of SEM revealed the hole diameter decrease from the reaction interface to the center position of carbon brick. The quantitative relationship between element content and erosion was obtained through the experimental results, the characteristic parameters were selected to compare the influence degree of element content on the erosion. The calculation model of mass transfer coefficient was established, the dissolution reaction of the sample is controlled by interfacial reaction and mass transfer of carbon when the phosphorus content up to 0.2% in molten iron. The adsorption of sulfur on the iron-carbon interface covers part of the effective surface, the degree of adsorption on the interface depends on the proportion of sites covered by sulfur.</p>
収録刊行物
-
- ISIJ International
-
ISIJ International 58 (5), 815-822, 2018-05-15
一般社団法人 日本鉄鋼協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282681464120064
-
- NII論文ID
- 130006742027
-
- ISSN
- 13475460
- 09151559
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可