異種金属複合ビレットの冷間押出しにおける不均一変形

  • 谷口 大將
    大阪大学大学院 工学研究科 マテリアル生産科学専攻
  • 宮本 丈二
    大阪大学大学院 工学研究科 マテリアル生産科学専攻
  • 松本 良
    大阪大学大学院 工学研究科 マテリアル生産科学専攻
  • 宇都宮 裕
    大阪大学大学院 工学研究科 マテリアル生産科学専攻

書誌事項

タイトル別名
  • Nonuniform Deformation in Cold Extrusion of Billet Assembled with Dissimilar Metals
  • イシュ キンゾク フクゴウ ビレット ノ レイカン オシダシ ニ オケル フキンイツ ヘンケイ

この論文をさがす

抄録

<p>Clad materials are multi–materials with combined dissimilar metals. Clad materials exhibit unique properties that no monolithic materials show. In this study, cold extrusion was conducted to produce a clad bar from an assembled billet, where core was inserted in a sheath. A hard–core billet was prepared using copper for the core and aluminum for the sheath. By swapping copper and aluminum, a soft–core billet was also prepared. Under constant outer diameter of the billet, core diameter was varied 4mm, 6mm and 8mm. Two dies with different hole diameters were used to change the extrusion ratio. Working conditions to attain uniform deformation was limited by fracture of either core or sheath. As for the hard–core billets, core fraction was limited by sausaging and void formation at center in case of low extrusion ratio. Fracture of sheath took place when the extrusion ratio was small and the volume fraction was large. As for the soft–core billet, the core fraction to obtain uniform deformation was wider. However, the sheath showed fracture when the extrusion ratio was large and the core fraction was high.</p>

収録刊行物

詳細情報

問題の指摘

ページトップへ