【2022年1月締切】CiNii ArticlesへのCiNii Researchへの統合に伴う機関認証の移行確認について

【1/6更新】2022年4月1日からのCiNii ArticlesのCiNii Researchへの統合について

パルスYAGレーザによる溶接部の熱処理 : パルスYAGによるマイクロ補修溶接の研究(第2報)

書誌事項

タイトル別名
  • Heat Treatment of Welds Using Pulsed YAG Laser : dy on the Micro Repair Welding by Pulsed YAG Laser (Report 2)

この論文をさがす

抄録

This study describes laser heat treatment of alloy tool steels SKD11 using pulsed YAG laser. When filler metal SUJ2 is welded to base metal SKD11 which metal is material of rotary cutter, the hardness of weld metal become lower than that of the base metal. In order to improve the hardness of weld metal which become lower than that of the base metal after laser welding, heat treatments using an electric furnace and pulsed YAG laser were carried out after laser welding, then examined the variation of hardness of weld metal after heat treatments. The obtained results are as follows. In the heat treatment using an electric furnace, the hardness of weld metal which become low against the base metal after laser welding become higher than that of the base metal under the conditions of heat treatment holding temperature at 180℃ and holding time from 30s to 120s, then take out the weld metal from the electric furnace and cooling from furnace temperature to room temperature. In the heat treatment using pulsed YAG laser, after laser welding in succession laser beam radiate at the surface of weld metal, the hardness of weld metal which become low against the base metal after laser welding become the same hardness as the base metal under the conditions of holding temperature at 180℃ and holding time from 30s to 120s, then cooling to room temperature.

収録刊行物

被引用文献 (0)*注記

もっと見る

参考文献 (0)*注記

もっと見る

関連論文

もっと見る

関連研究データ

もっと見る

関連図書・雑誌

もっと見る

関連博士論文

もっと見る

関連プロジェクト

もっと見る

関連その他成果物

もっと見る

詳細情報

ページトップへ