【2022年1月締切】CiNii ArticlesへのCiNii Researchへの統合に伴う機関認証の移行確認について

【1/6更新】2022年4月1日からのCiNii ArticlesのCiNii Researchへの統合について

接触型三次元デジタイザー計測システムの歯科領域への応用

書誌事項

タイトル別名
  • A Study of the Applicability of 3D Digitizer and Modeling System to Dental Plaster Model Measurements

この論文をさがす

抄録

Morphological observation of dental plaster model has been studied in many methods. In measurement of dental plaster model, measurements are made using slide calipers or by taking moire photograph, with the recent improvement in advanced data analysis using computers, instruments have been developed that enable both measurement and analysis of three-dimensional data as well as statistical analysis using various techniques. However, the clinical application of these techniques in dentistry is not always easy since expensive instruments are required, their operation is too complicated, and three-dimensional measurements cannot be always performed. The present study used a newly developed contact-type three-dimensional measurement system (Space Arm, Faro Inc.) to evaluate the reliability of measurements from points previously set on dental plaster models in relation to a virtual plane, and the applicability of this instrument in dentistry. The results indicated that this contact-type three-dimensional measurement instrument satisfies the various requirements for measurement in dentistry and demonstrated objectivity, reproducibility and convenience, all of which are essential for measurement in dentistry. Therefore, it was concluded that the instrument is practical for measurements in dentistry, especially measurements relating to three-dimensional virtual planes.

収録刊行物

  • 松本歯学

    松本歯学 22 (3), 283-286, 1996-12-31

    松本歯科大学学会

被引用文献 (0)*注記

もっと見る

参考文献 (0)*注記

もっと見る

関連論文

もっと見る

関連研究データ

もっと見る

関連図書・雑誌

もっと見る

関連博士論文

もっと見る

関連プロジェクト

もっと見る

関連その他成果物

もっと見る

詳細情報

ページトップへ