書誌事項
- タイトル別名
-
- Study on Effect of Cutting Fluid (1st report) : Orthogonal Cutting on Various Materials by High Speed Steel Tool
- ユザイ ノ コウカ ニ カンスル ケンキュウ ダイ1ポウ コウソクド ハガネ コウグ ニヨル カクシュ ヒサクザイ ノ ニジゲン セッサク
- 高速度鋼工具による各種被削材の二次元切削
この論文をさがす
説明
This is a report on the effects of cutting fluids, when various metallic materials are cut under orthogonal cutting at constant cutting speed. The effects of cutting fluids on cutting force, shear angle, etc. are investigated in the experiments. The kinds of cutting fluids used are water, water base and mineral oil base. The materials used in this experiment are carbon steel S10C, S15C, alloy steel SCM4,18-8 stainless steel (SUS27), cast iron (FC20) and 4-6 brass. The results obtained are as follows. 1. In such a low cutting speed as V=10m/min, cutting force and coefficient of friction decrease and shear angle increases by using the cutting fluids. The effect of the mineral oil base is greater than the water base. 2. The chip's type is often transformed to flow type from shear type by cutting fluids. 3. The effect of cutting fluids is greater in carbon steel than SUS27 with which the chips easier weld to the tool.
収録刊行物
-
- 山口大学工学部研究報告
-
山口大学工学部研究報告 20 (1), 133-141, 1969
山口大学工学部
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1050001337452030208
-
- NII論文ID
- 110001063091
-
- NII書誌ID
- AN00244228
-
- ISSN
- 03727661
-
- NDL書誌ID
- 8465430
-
- 本文言語コード
- ja
-
- 資料種別
- departmental bulletin paper
-
- データソース種別
-
- IRDB
- NDL
- CiNii Articles