Development of a fiber structure in poly(vinylidene fluoride) by a CO(2) laser-heated drawing process

IR HANDLE Web Site 1 Citations 17 References

Search this article

Abstract

Rapid and uniform heating by CO(2) laser radiation can fix the position where necking occurs. Therefore, this study investigated the development of a fiber structure in poly(vinylidene fluoride) in continuous drawing by in situ measurement using synchrotron X-ray radiation with a time resolution of several hundred microseconds. Two neck-deformation behaviors were observed in the laser drawing: a moderate neck deformation under low drawing stress and a steep neck deformation under high drawing stress. The low drawing stress resulted in a mixture of alpha- and beta-crystals in which the beta-crystal was formed within 1ms after the necking, earlier than the alpha-crystal. The development of the fiber structure under high drawing stress was almost complete in less than 1 ms, and the developed structure contained only beta-crystals. Small-angle X-ray scattering images showed meridional streaks at low drawing stress, whereas a four-pointed pattern occurred under high drawing stress. Low drawing stress generated a long periodic structure that was defective in the periodic regularity of crystalline and amorphous regions, although the molecular chains were nearly oriented along the fiber axis. The high drawing stress resulted in a well-packed structure of adjacent fibrils with alternating amorphous and crystalline regions. Polymer Journal (2010) 42, 657-662; doi: 10.1038/pj.2010.53; published online 23 June 2010

Article

POLYMER JOURNAL. 42(8):657-662 (2010)

Journal

  • POLYMER JOURNAL

    POLYMER JOURNAL 42 (8), 657-662, 2010-08

    NATURE PUBLISHING GROUP

Citations (1)*help

See more

References(17)*help

See more

Keywords

Details 詳細情報について

Report a problem

Back to top