書誌事項
- タイトル別名
-
- 異なる鋭さをもつ切欠部の降状の実物光塑性解析
- コトナル スルドサ オ モツ キリカケブ ノ コウジョウ ノ ジツブツ コウソセイ カイセキ
- On a Photoelasto-Plastic Analysis of the Yielding of Notched Parts With Various Sharpnesses by Means of the Coating Method.
この論文をさがす
抄録
底部の曲率半径Rを変えた90°V形切欠および半円形切欠をもつ構造要素が,切欠底部で局部的降伏をおこし,更に無制限流れに至る過程を,アルミニウム合金試験片にエポキシ・ポリサルファイド共重合体(エポキシ・ラバー)皮膜を接着し,実物光塑性により解析した.この結果,切欠底の弾塑性応力集中係数σ/σ_0および歪εの基準応力σ_0による変化の模様が明らかにされ,局部的降伏開始後のσ/σ_0~σ_0関係は切欠の鋭さによらず略同一の双曲線状曲線にのること,R→0の場合も含め,P_Y(flow limit)/P_<Y0>(局部的降伏のはじまる荷重)〓1.75~3.7程度の値をとることが知られた.
The processes of local yielding and unrestricted flow in uniaxial tension tests of notched Al alloy specimens are analyzed by means of photoelastic coating method, using an epoxy-polysulfide copolymer as the coating material. The shapes of notches are classified into two series: one is 90°V-shaped notch and the other is semicircular notch. The radii of curvature R at the bottoms of the notches are varied in the range between 5mm and nearly 0mm. The variation of elasto-plastic stress concentration factors σ/σ_0 and strains ε at the bottoms of the notches with standard stress σ_0 are clarified. The plots of σ/σ_0 versus σ_0 are shown by a hyperbola-like curve irrespective of the sharpness of notches, after the beginning of local yielding. The values of the ratio P_Y (flow limit)/P_<Y0> (the load at which a local yielding begins) are obtained as 1.75~3.7 for all tested cases including R→0.
資料番号: SA4134990000
収録刊行物
-
- 東京大学航空研究所集報
-
東京大学航空研究所集報 2 (4), 198-207, 1960-12
東京大学航空研究所
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1050003824962793856
-
- NII論文ID
- 110004531240
-
- NII書誌ID
- AN00162214
-
- ISSN
- 05638097
-
- NDL書誌ID
- 9125682
-
- 本文言語コード
- ja
-
- 資料種別
- departmental bulletin paper
-
- データソース種別
-
- IRDB
- NDL
- CiNii Articles