書誌事項
- タイトル別名
-
- マッチングホウ オ テキヨウ シタ カコウ クミタテ システム ニ オケル ブ
この論文をさがす
抄録
A'matching method' is widely used in a machining assembly system for high quality products. However, parts composing products have a machining error, and the error distributions of parts are usually different froin each other. This causes unmated parts, which stagnate in buffers, and decreases the production rate. So, it is necessary to control the machining size of one type of parts to decrease unmated parts. In this paper we propose a new size control policy to improve the production rate, and study the part flow using a simulation method. From the simulation results, it is presented that the new policy increases the production rate and the effectiveness depends on the combination of machining error distributions.
収録刊行物
-
- 日本機械学會論文集. C編
-
日本機械学會論文集. C編 64 (627), 4428-4433, 1998-11-01
社団法人日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1050298588048508288
-
- NII論文ID
- 110002393673
- 10010748510
-
- NII書誌ID
- AN00187463
-
- ISSN
- 03875024
-
- NDL書誌ID
- 4612487
-
- 本文言語コード
- ja
-
- 資料種別
- journal article
-
- データソース種別
-
- IRDB
- NDL
- CiNii Articles