書誌事項
- タイトル別名
-
- Effects of YAG Laser Cutting and Post Heat Treatment on Stretch-flangeability of TRIP steels with Polygonal Ferrite Matrix
- ポリゴナル フェライト ボソウ オ ユウスル TRIP コウハン ノ ノビ フランジセイ ニ オヨボス YAG レーザ セツダン ト コウネツ ショリ ノ エイキョウ ノ エイキョウ
- Effects of YAG Laser Cutting and Post Heat Treatment on Stretch-flangeability of TRIP steels with Polygonal Ferrite Matrix
この論文をさがす
説明
The effects of YAG laser cutting and post heat treatment on the stretch-flangeability of transformation-induced plasticity (TRIP)-aided sheet steels (TRIP steels), which had different content of C was examined. In TRIP steels in which Si and Mn contents were constant and C content was varied ((0.1-0.4)C-1.5Si-1.5Mn, mass%), the strength-stretch-flangeability balance (TS×λ) of holes obtained by either laser cutting, mechanical punching or drilling decreased with increasing C content. When the C content was 0.3 mass% or higher, the hole-expanding ratio (λ) value in the case of laser cutting, which originally was as good as that in the case of drilling, decreased to a level comparable to that in the case of mechanical punching. On the other hand, in TRIP steels of 0.3mass% C or higher the λ value of the hole obtained by laser cutting was low under high tensile strength (TS); however, the value was greatly improved by the post heat treatment. Based on the abore results, we demonstrated that the post heat treatment contributes to the improvement of the stretch-flangeability of (0.2-0.4)C-1.5Si-1.5Mn TRIP steels with polygonal ferrite matrix.
収録刊行物
-
- 長野工業高等専門学校紀要
-
長野工業高等専門学校紀要 40 1-6, 2006-06-30
長野工業高等専門学校
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1050564287567340672
-
- NII論文ID
- 110005001234
-
- NII書誌ID
- AN00179170
-
- ISSN
- 02861909
-
- NDL書誌ID
- 8633824
-
- 本文言語コード
- ja
-
- 資料種別
- departmental bulletin paper
-
- データソース種別
-
- IRDB
- NDL
- CiNii Articles