埋没材の硬化時膨張および加熱膨張に対する力学的解析

書誌事項

タイトル別名
  • Dynamic Stress Analysis on Effects of Length to Setting and Thermal Expansions of the Investment

この論文をさがす

抄録

application/pdf

In this report, effects of length to setting and thermal expansions, (they were published by Yamane (1966) and Kozono (1971)) were elucidated by means of the dynamic stress analysis. Results were follows; 1. Setting expansion of the investment is prevented by casting ring and embedded wax pattern. The deformation of the mold is caluculated as the same as the elastic material's deformation, with thier Young's modulus and Poisson's ratio. 2. The thermal expansion (a) of the investment is influenced externaly by the preventions against setting expansion due to casting ring and embedded wax pattern. But it is determined by the following equation, when the investment is heated higher than 300℃. a=a_1+a_2a (f/f-β) -γ a; Thermal expansion modulus of the investment. a_1; Sum of thermal expansion caused with the refractory and the bonding material. a_2; Absolute value of difference between thermal expansion modulus of the refractory and that of the bonding material. a; Invariable number determined by the investment. f; Porosities observed between the refractory and the bonding material. β; Variation of porosities caused by some out side factors. γ; Shrinkage caused by dehydration, heating at 200℃.

収録刊行物

  • 松本歯学

    松本歯学 5 (2), 213-222, 1979-12-31

    松本歯科大学学会

詳細情報 詳細情報について

問題の指摘

ページトップへ