Heat transfer characteristics of flat evaporator loop heat pipe under high heat flux condition with different orientations

DOI Web Site Web Site 被引用文献4件 参考文献23件

書誌事項

公開日
2019-05
資源種別
journal article
権利情報
  • https://www.elsevier.com/tdm/userlicense/1.0/
  • https://www.elsevier.com/legal/tdmrep-license
  • http://www.elsevier.com/open-access/userlicense/1.0/
DOI
  • 10.1016/j.applthermaleng.2019.02.022
公開者
Elsevier BV

この論文をさがす

説明

Abstract This paper reports an experimental study on a high heat flux loop heat pipe (LHP) with different orientations. A flat rectangular evaporator with a dimension of 51 mm (L) × 68 mm (W) × 15 mm (H) was designed. To enhance a heat transfer performance at a high heat flux, width and number of vapor groove which is processed in a porous wick designed to 0.3 mm and 84, respectively. The LHP was tested in six orientations such as (1) Evaporator under condenser, (2) Wick above liquid core, (3) Evaporator under CC, (4) Evaporator above condenser, (5) Wick under liquid core, and (6) Evaporator above CC. The main originality of this paper is to evaluate the effect of LHP orientation on the heat transfer performance under high heat flux condition. As results of the experiment, it was confirmed that the LHP successfully started up at 50 W for all orientations. In the case of orientation (3) and (5), the maximum heat transfer capacity became the highest value such as 280 W (19.6 W/cm2). The lowest thermal resistances of them were 0.094 K/W and 0.064 K/W, respectively. It was found that the LHP orientation and liquid-vapor phase distribution in the liquid core significantly affected the heat transfer performance when the high heat flux was applied.

収録刊行物

被引用文献 (4)*注記

もっと見る

参考文献 (23)*注記

もっと見る

関連プロジェクト

もっと見る

問題の指摘

ページトップへ