Sequencing DNA with nanopores: Troubles and biases

<jats:p>Oxford Nanopore Technologies’ (ONT) long read sequencers offer access to longer DNA fragments than previous sequencer generations, at the cost of a higher error rate. While many papers have studied read correction methods, few have addressed the detailed characterization of observed errors, a task complicated by frequent changes in chemistry and software in ONT technology. The MinION sequencer is now more stable and this paper proposes an up-to-date view of its error landscape, using the most mature flowcell and basecaller. We studied Nanopore sequencing error biases on both bacterial and human DNA reads. We found that, although Nanopore sequencing is expected not to suffer from GC bias, it is a crucial parameter with respect to errors. In particular, low-GC reads have fewer errors than high-GC reads (about 6% and 8% respectively). The error profile for homopolymeric regions or regions with short repeats, the source of about half of all sequencing errors, also depends on the GC rate and mainly shows deletions, although there are some reads with long insertions. Another interesting finding is that the quality measure, although over-estimated, offers valuable information to predict the error rate as well as the abundance of reads. We supplemented this study with an analysis of a rapeseed RNA read set and shown a higher level of errors with a higher level of deletion in these data. Finally, we have implemented an open source pipeline for long-term monitoring of the error profile, which enables users to easily compute various analysis presented in this work, including for future developments of the sequencing device. Overall, we hope this work will provide a basis for the design of better error-correction methods.</jats:p>