Simulation of the mechanical unfolding of ubiquitin: Probing different unfolding reaction coordinates by changing the pulling geometry

  • Pai-Chi Li
    Department of Chemistry and Biochemistry and Institute for Theoretical Chemistry, University of Texas at Austin, Austin, Texas 78712
  • Dmitrii E. Makarov
    Department of Chemistry and Biochemistry and Institute for Theoretical Chemistry, University of Texas at Austin, Austin, Texas 78712

抄録

<jats:p>Motivated by the recent experimental atomic force microscopy (AFM) measurements of the mechanical unfolding of proteins pulled in different directions [D. J. Brockwell et al., Nat. Struct. Biol. 10, 731 (2003); M. Carrion-Vazquez et al., ibid 10, 738 (2003)] we have computed the unfolding free energy profiles for the ubiquitin domain when it is stretched between its (A) N and C termini, (B) Lys48 and C terminus, (C) Lys11 and C terminus, and (D) N terminus and Lys63. Our results for cases (A) and (B) are in good agreement with the experimental unfolding forces measured for the N-C and Lys48-C linked polyubiquitin, in particular, indicating a considerably lower unfolding force in the latter case. Mechanical unfolding in case (A) involves longitudinal shearing of the terminal parallel strands while in case (C) the same strands are “unzipped” by the force. The computed unfolding forces in case (C) are found to be very low, less than 50 pN for pulling rates typical of AFM experiments. The unfolding free energy barrier found in case (C) is ∼13 kcal/mol, which corresponds to a zero-force unfolding rate constant that is comparable to the rate of chemical unfolding extrapolated to zero denaturant concentration. The unfolding barrier calculated in case (A) in the limit of zero force is much higher, suggesting that mechanical unfolding in this case follows a pathway that is different from that of thermal/chemical denaturation.</jats:p>

収録刊行物

被引用文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ