3D printing of conjugated polymers

DOI Web Site Web Site Web Site 被引用文献2件
  • Robert S. Jordan
    Department of Materials Science and Engineering University of California, Merced Merced California 95343
  • Yue Wang
    Department of Materials Science and Engineering University of California, Merced Merced California 95343

抄録

<jats:title>ABSTRACT</jats:title><jats:p>Three‐dimensional (3D) printing brings exciting prospects to the realm of conjugated polymers (CPs) and organic electronics through vastly enhanced design flexibility, structural complexity, and environmental sustainability. However, the use of 3D printing for CPs is still in its infancy and remains full of challenges. In this review, we highlight recent studies that demonstrate proof‐of‐concept strategies to mitigate some of these problems. Two general additive manufacturing approaches are featured: direct ink writing and vat photopolymerization. We conclude with an outlook for this thriving field of research and draw attention to the new possibilities that 3D printing can bring to CPs. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. <jats:bold>2019</jats:bold>, 57, 1592–1605</jats:p>

収録刊行物

被引用文献 (2)*注記

もっと見る

キーワード

問題の指摘

ページトップへ