Mechanical property changes of low activation ferritic/martensitic steels after neutron irradiation

DOI Web Site Web Site 被引用文献4件

書誌事項

公開日
1999-05
権利情報
  • https://www.elsevier.com/tdm/userlicense/1.0/
DOI
  • 10.1016/s0022-3115(98)00735-1
公開者
Elsevier BV

この論文をさがす

説明

Abstract Mechanical property changes of Fe–XCr–2W–0.2V,Ta (X: 2.25–12) low activation ferritic/martensitic steels including Japanese Low Activation Ferritic/martensitic (JLF) steels and F82H after neutron irradiation were investigated with emphasis on Charpy impact property, tensile property and irradiation creep properties. Dose dependence of ductile-to-brittle transition temperature (DBTT) in JLF-1 (9Cr steel) irradiated at 646–700 K increased with irradiation up to 20 dpa and then decreased with further irradiation showing highest DBTT of 260 K at 20 dpa. F82H showed similar dose dependence in DBTT to JLF-1 with higher transition temperature than that of JLF-1 at the same displacement damage. Yield strength in JLF steels and F82H showed similar dose dependence to that of DBTT. Yield strength increased with irradiation up to 15–20 dpa and then decreased to saturate above about 40 dpa. Irradiation hardening in 7–9%Cr steels (JLF-1, JLF-3, F82H) were observed to be smaller than those in steels with 2.25%Cr (JLF-4) or 12%Cr (JLF-5). Dependences of creep strain on applied hoop stress and neutron fluence were measured to be 1.5 and 1, respectively. Temperature dependence of creep coefficient showed a maximum at about 700 K which was caused by irradiation induced void formation or irradiation enhanced creep deformation. Creep coefficient of F82H was larger than those of JLF steels above 750 K. This was considered to be caused by the differences in N and Ta concentration between F82H and JLF steels.

収録刊行物

被引用文献 (4)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ