Simultaneous polymerization and formation of polyacetylene film on the surface of concentrated soluble Ziegler‐type catalyst solution

DOI DOI Web Site Web Site 被引用文献72件

この論文をさがす

説明

<jats:title>Abstract</jats:title><jats:p>A direct method of simultaneously polymerizing and forming acetylene monomer to produce uniformly thin films of polyacetylene was investigated in terms of catalyst system, catalyst concentration, and polymerization temperature. The best catalyst was a Ti(OC<jats:sub>4</jats:sub>H<jats:sub>9</jats:sub>)<jats:sub>4</jats:sub>–Al(C<jats:sub>2</jats:sub>H<jats:sub>5</jats:sub>)<jats:sub>3</jats:sub> system (Al/Ti = 3–4) and the critical concentration was 3 mmole/l. of Ti(OC<jats:sub>4</jats:sub>H<jats:sub>9</jats:sub>)<jats:sub>4</jats:sub>. Below the critical concentration, only a solid or a powder was obtained. The configuration of the polymers obtained depends strongly upon the polymerization temperature. Thus an all‐<jats:italic>cis</jats:italic> polymer was obtained at temperatures lower than −78°C, whereas an all‐<jats:italic>trans</jats:italic> polymer resulted at temperatures higher than 150°C. Observations either in an electron microscope by direct transmission or in a scanning electron microscope showed that the film is composed of an accumulation of fibrils about 200–300 Å in width and of indefinite length.</jats:p>

収録刊行物

被引用文献 (72)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ