Isothermal Elastohydrodynamic Lubrication of Point Contacts: Part III—Fully Flooded Results

DOI PDF 被引用文献20件

書誌事項

公開日
1977-04-01
DOI
  • 10.1115/1.3453074
公開者
ASME International

この論文をさがす

説明

<jats:p>Utilizing the theory developed by the authors in an earlier publication, the influence of the ellipticity parameter, the dimensionless speed, load, and material parameters on minimum film thickness was investigated. The ellipticity parameter was varied from one (a ball on a plate configuration) to eight (a configuration approaching a line contact). The dimensionless speed parameter was varied over a range of nearly two orders of magnitude. The dimensionless load parameter was varied over a range of one order of magnitude. Conditions corresponding to the use of solid materials of bronze, steel, and silicon nitride and lubricants of paraffinic and naphthenic mineral oils were considered in obtaining the exponent in the dimensionless material parameter. Thirty-four different cases were used in obtaining the minimum film thickness formula given below as H¯min=3.63U0.68G0.49W−0.073(1−e−0.68k) A simplified expression for the ellipticity parameter was found where k=1.03RyRx0.64 Contour plots were also shown which indicate in detail the pressure spike and two side lobes in which the minimum film thickness occurs. These theoretical solutions of film thickness have all the essential features of the previously reported experimental observations based upon optical interferometry.</jats:p>

収録刊行物

被引用文献 (20)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ