キサントゲン酸塩錯体の活性炭吸着分離/黒鉛炉原子吸光法による底質中の微量タリウムの定量

書誌事項

タイトル別名
  • Determination of trace amounts of thallium in some sediments by graphite furnace AAS after preconcentration as xanthogenate complex on activated carbon.
  • キサントゲンサンエン サクタイ ノ カッセイタン キュウチャク ブンリ コクエ

この論文をさがす

抄録

A rapid and simple preconcentration method by selective adsorption using activated carbon as an adsorbent and potassium O-ethyldithiocarbonate (potassium xanthogenate) is described for the determination of trace amounts of thallium in sediments by graphite furnace AAS. The procedure is as follows: to 100cm3 of sample solution containing less than 0.5μg of thallium, 60mg of potassium xanthogenate and 60mg of activated carbon were added. The pH was then adjusted to 8.0-10.0 using dilute ammonia water. The mixture was allowed to stand for approximately 20min, then mixed for 20s in an ultrasonic agitator and then filtered. The activated carbon which adsorbed the thallium complex was separated from the matrixes. The activated carbon on the filter paper was dispersed in 5cm3 of water by mixing using an ultrasonic agitator. After shaking, 10μl of the suspension was directly injected into the graphite furnace. Both palladium and ascorbic acid were used as matrix modifiers for thallium. The proposed method was used to determine the amount of several environmental reference standard materials, river and marine bottom sediments. The results for standard materials were in good agreement with the certified or reference values. This simple method is suitable for the determination of trace amounts of thallium in the sample containing large amounts of Fe, Al, Ca, Ti and the other elements.

収録刊行物

  • 分析化学

    分析化学 40 (5), 251-256, 1991

    公益社団法人 日本分析化学会

被引用文献 (9)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ