グラビア製版用電析銅めっき皮膜の添加剤濃度による物性と彫刻適性

  • 阿部 秀夫
    凸版印刷 (株) 総合研究所 生産技術研究所
  • 松永 和夫
    凸版印刷 (株) 生産技術センター グラビア製版技術
  • 伊藤 竜男
    凸版印刷 (株) 生産技術センター グラビア製版技術
  • 渡辺 徹
    芝浦工業大学工学部材料工学科

書誌事項

タイトル別名
  • Physical Properties and Aptitude for Engraving of Electrodeposited Copper Plating Film for Gravure Cylinder by Concentration of Additives
  • グラビア セイハンヨウデンセキドウメッキ ヒマク ノ テンカザイ ノウド ニ ヨル ブッセイ ト チョウコク テキセイ

この論文をさがす

抄録

In a previous report, we studied the effect on the physical properties of electrodeposited copper plating film for gravure cylinder by using the commercial additive agents(COSMO G series)and verified the validity of the estimation method for the concentration of hardener. Here results on the continuation of the study for the the physical properties of electrodeposited film and the aptitude for engraving are presented. The Vickers hardness and elongation at high current density are similar to the results in a previous report. The concentration of G-1 was estimated using the equation simulated from the multiple regression analysis. The correlation efficient of the applied and estimated concentration of G-1 is 0.941 when the concentration of G-1 varies from 0.5 to 4 ml⁄l. The falling speed of tensile strength by acceleration test at 95°C is about 600∼1, 000 times as fast as that of aging test at 25°C. It was found that the half-life time of tensile strength by the acceleration test can be estimated this by aging test. The relationship between the half-life time of tensile strength and the reciprocal of absolute temperature is linear. This suggests that the time of re-crystallization is due to the applied temperature. When the cylinder is electroplated in G-1 concentration 0.5 ml⁄l and aged at room temperature, the volume of cell(∠0)deviates from that of cylinder which is electroplated in G-1 concentration 1.0 ml⁄l or above. This is because the Vickers hardness falls whereas the elongation increases by aging and the cell shape consequently deteriorates.

収録刊行物

参考文献 (13)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ