Improvements in Quality of As-Manufactured Fuels for High-Temperature Gas-Cooled Reactors.
-
- MINATO Kazuo
- Department of Chemistry and Fuel Research Japan Atomic Energy Research Institute
-
- KIKUCHI Hironobu
- Department of Chemistry and Fuel Research Japan Atomic Energy Research Institute
-
- TOBITA Tsutomu
- Department of Chemistry and Fuel Research Japan Atomic Energy Research Institute Department of HTTR Project Japan Atomic Energy Research Institute
-
- FUKUDA Kousaku
- Department of Chemistry and Fuel Research Japan Atomic Energy Research Institute
-
- KANEKO Mitsunobu
- Advanced Reactor Fuels Division Nuclear Fuel Industries Ltd. Nuclear Fuel Industries Ltd.,
-
- SUZUKI Nobuyuki
- Advanced Reactor Fuels Division Nuclear Fuel Industries Ltd. Health Physics Safety & Maintenance Department Tokai Works Nuclear Fuel Industries Ltd.
-
- YOSHIMUTA Shigeharu
- Advanced Reactor Fuels Division Nuclear Fuel Industries Ltd.
-
- TOMIMOTO Hiroshi
- Advanced Reactor Fuels Division Nuclear Fuel Industries Ltd.
書誌事項
- タイトル別名
-
- Improvements in Quality of As-Manufactu
この論文をさがす
抄録
The mechanisms of coating failure of the fuel particles for the high-temperature gas-cooled reactors during coating and compaction processes of the fuel fabrication were studied to determine a way to reduce the defective particle fraction of the as-manufactured fuels. Through the observation of the defective particles, it was found that the coating failure during the coating process was mainly caused by the strong mechanical shocks to the particles given by violent particle fluidization in the coater and by unloading and loading of the particles. The coating failure during the compaction process was probably related to the direct contact with neighboring particles in the fuel compacts. The coating process was improved by optimizing the mode of the particle fluidization and by developing the process without unloading and loading of the particles at intermediate coating process. The compaction process was improved by optimizing the combination of the pressing temperature and the pressing speed of the overcoated particles. Through these modifications of the fabrication process, the quality of the as-manufactured fuel compacts was improved outstandingly.
収録刊行物
-
- Journal of Nuclear Science and Technology(日本原子力学会英文論文誌)
-
Journal of Nuclear Science and Technology(日本原子力学会英文論文誌) 34 (3), 325-333, 1997
一般社団法人 日本原子力学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204096028160
-
- NII論文ID
- 10002076838
-
- NII書誌ID
- AA00703720
-
- COI
- 1:CAS:528:DyaK2sXivFWksbk%3D
-
- ISSN
- 18811248
- 00223131
-
- NDL書誌ID
- 4176287
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可