アルミニウムの陽極酸化皮膜へのシリカ被覆による触媒担体の調製

DOI Web Site 被引用文献3件 参考文献17件

書誌事項

タイトル別名
  • Preparation of Catalyst Support through a Silica Coating for Anodized Aluminum.
  • アルミニウム ノ ヨウキョク サンカ ヒマク エ ノ シリカ ヒフク ニ ヨル ショクバイ タンタイ ノ チョウセイ

この論文をさがす

抄録

In order to obtain a SiO2 layer as a catalyst support on a surface of aluminum, silica coating on an anodized aluminum plate has been investigated. The catalyst support plate was prepared by impregnating an anodized aluminum plate into silica sol and calcinating it. Results indicated that adding oxalic acid to silica sol is effective in increasing the amount of silica, but adding other acids to the sol form a gel within 100h. The amount of silica applied increases with an increase in the temperature and the impregnation time. However, the amount decreased as the amount of alumina layer that had dissolved increased. The BET surface area of the coated specimens increased as the Si content increased. The maximum surface area relative to the apparent geometrical surface area was approximately 6000m2·m-2, which was more than twice that before coating, demonstrating that it is possible to apply the coating as a catalyst support. Results of plate characterization indicated that the alumina layer formed by anodizing dissolved in the presence of oxalic acids enlarging the pores that were then filled with silica particles.

収録刊行物

  • 表面技術

    表面技術 51 (11), 1159-1164, 2000

    一般社団法人 表面技術協会

被引用文献 (3)*注記

もっと見る

参考文献 (17)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ