Reproducibility of measurements of occlusal contact area obtained with an occlusal examination device

  • Furuichi Eiji
    Department of Fixed Prosthodontics and Occlusion, Osaka Dental University
  • Kashiwagi Kosuke
    Department of Fixed Prosthodontics and Occlusion, Osaka Dental University
  • Kawazoe Takayoshi
    Department of Fixed Prosthodontics and Occlusion, Osaka Dental University

Bibliographic Information

Other Title
  • 咬合接触検査装置による咬合接触面積測定の再検査信頼性に関する研究
  • コウゴウセッショク ケンサ ソウチ ニ ヨル コウゴウセッショク メンセキ ソクテイ ノ サイケンサ シンライセイ ニ カンスル ケンキュウ

Search this article

Abstract

We investigated reproducibility of measurements of occlusal contact area obtained with the T-Scan II, which is an occlusal examination device. The subjects were ten males with healthy, complete dentition. We measured the occlusal contact area at the five levels for 25, 50, 75, 90, and 100% maximum voluntary contraction (MVC). Five repetitions were made for each measurement over two days. Reproducibility of the occlusal contact area measurements was evaluated by the single-factor repeated measures analysis of variance, the standard error of measurement and the intraclass correlation coefficient. The most stable measurements were obtained from the second and third clenching tests. The reliability for same-day measurements was higher than that for different-day measurements. In the same-day measurements, the reliability at 25% and 50% MVC was lower than that at the three other clenching levels. For different-day measurements, the reliability for all clenching levels was essentially the same. The average measurements showed better clinical reliability than did single measurements for the same-day and different-day measurements. We found reproducibility for the same-day and different-day measurements of occlusal contact area with the T-Scan II.

Journal

  • Shikaigaku

    Shikaigaku 68 (2), 199-206, 2005

    Osaka Odontological Society

Citations (3)*help

See more

References(22)*help

See more

Details 詳細情報について

Report a problem

Back to top