書誌事項
- タイトル別名
-
- 3D Hydraulic Conductivity Modeling of Fractured Granitic Body Using Geostatistical Techniques and Its Application to Regional Groundwater Flow Analysis
- チキュウ トウケイガクテキ シュホウ ニ ヨル キレツセイ ハナオカガンタイ ノ 3ジゲン トウスイ ケイスウ モデリング ト コウイキ チカ ミズリュウドウ カイセキ エ ノ オウヨウ
この論文をさがす
抄録
Numerical simulations have been the most effective method for estimating flow pattern, flux, and flow velocity of the groundwater to precisely characterize large-scale groundwater systems. Spatial modeling of the 3D distribution of hydraulic conductivity over a study area is indispensable to obtain accurate simulation results. However, such spatial modeling is difficult in most cases due to the limitations of hydraulic conductivity data in terms of their volume and location. To overcome these problems and establish an advanced technique, we adopt geostatistics and combine a fracture distribution model with measured conductivity data, selecting the Tono area situated in Gifu Prefecture, central Japan for the field study. The size of the main target area covers 12 km (E-W) by 8 km (N-S), with a depth range of 1.5 km, and it is chiefly underlain by Cretaceous granite. Because the distribution of 395 hydraulic test data acquired along the 25 deep boreholes was biased, the data values were compared to the dimensions of simulated fractures using GEOFRAC. As a result, a positive correlation was identified. Using a regression equation for the correlation, hydraulic conductivity values were assigned to every simulated fracture. Then, a sequential Gaussian simulation (SGS) was applied to construct a 3D spatial model of hydraulic conductivity using those assumed values and actual test data. The plausibility of the resulting model was confirmed through the continuity of high and low permeable zones. The next step is a groundwater flow simulation using MODFLOW and the model. The simulation results were regarded to be appropriate because distribution of hydraulic head, locations of major discharge points, and anisotropy of hydraulic behavior of the Tsukiyoshi fault correspond to the results of observations. The most noteworthy feature detected in the groundwater flow model from the simulation results is that descending flow, horizontal southward flow at depth, and ascending flow are formed from recharge to discharge areas passing through the Tsukiyoshi fault, which agree with the configuration of the continuous simulated fractures.
収録刊行物
-
- 地学雑誌
-
地学雑誌 122 (1), 139-158, 2013
公益社団法人 東京地学協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204237107328
-
- NII論文ID
- 130003302678
- 40019612817
-
- NII書誌ID
- AN00322536
-
- ISSN
- 18840884
- 0022135X
-
- NDL書誌ID
- 024346543
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可