-
- Katanoda Hiroshi
- Department of Mechanical Engineering, Kagoshima University
-
- Matsuo Kazuyasu
- Department of Mechanical Systems and Environmental Engineering, The University of Kitakyushu
この論文をさがす
抄録
The gas flow of aerosol deposition method (ADM) is simulated using the method of computational fluid dynamics (CFD), and the velocity of particles flowing in the gas flow is also calculated by numerically integrating Newton’s second law of motion. The process gas is nitrogen and the particle material is Pb(Zr,Ti)O3 (PZT). The calculated particle velocities are compared with experimental results obtained by using a slit-cell method (SCM), which may disturb the gas-particle jet-flow of ADM during the measurement of particle velocity. The comparison of calculated and measured results reveals that the SCM can cause unexpected measurement error due to disturbing the gas-particle jet-flow caused by the stagnation pressure exceeding a certain value.
収録刊行物
-
- MATERIALS TRANSACTIONS
-
MATERIALS TRANSACTIONS 47 (7), 1620-1625, 2006
公益社団法人 日本金属学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204250265344
-
- NII論文ID
- 130004453180
- 10017997635
-
- NII書誌ID
- AA1151294X
-
- ISSN
- 13475320
- 13459678
-
- NDL書誌ID
- 7978795
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可