Rate Independent and Rate Dependent Structural Evolution during Severe Plastic Deformation

DOI Web Site Web Site 被引用文献7件 参考文献38件

この論文をさがす

説明

High pressure torsion (HPT) deformation enables the grain refinement of bulk materials until a saturation region is reached where no further microstructural refinement can be observed. The influence of deformation temperature, alloying and strain rate on the saturation region was examined by using pure aluminum, an Al-1 mass%Mg alloy and an Al-3 mass%Mg alloy. The deformation temperature was varied between −196°C and 450°C. Both, temperature and alloying exhibit a pronounced influence on the saturation microstructure. The measurements reveal either a rate independent behavior of the structural evolution at low temperatures and a rate dependent behavior of the structural evolution at high temperatures. Two different processes are proposed to be the reason for the saturation at low and high homologous temperatures.

収録刊行物

被引用文献 (7)*注記

もっと見る

参考文献 (38)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ