配管エルボ部の欠陥検出におけるガイド波試験の欠陥検出感度の周波数依存性
-
- Yamamoto Toshihiro
- Nondestructive Evaluation Center, Japan Power Engineering and Inspection Corporation
-
- Furukawa Takashi
- Nondestructive Evaluation Center, Japan Power Engineering and Inspection Corporation
-
- Nishino Hideo
- Institute of Technology and Science, the University of Tokushima
書誌事項
- タイトル別名
-
- Frequency Dependence of the Defect Sensitivity of Guided Wave Testing for Efficient Defect Detection at Pipe Elbows
- ハイカン エルボブ ノ ケッカン ケンシュツ ニ オケル ガイドハ シケン ノ ケッカン ケンシュツ カンド ノ シュウハスウ イソンセイ
この論文をさがす
説明
Guided wave testing offers an efficient screening method for thinning of pipe walls because of its long inspection range and its ability to inspect pipes with limited access. However, the existence of an elbow in pipes makes the interpretation of echo signals difficult. The present study investigates the sensitivity of defect detection when guided wave testing is applied to detect a defect at a pipe elbow. To examine the defect sensitivity when a defect exists at different locations on an elbow, an artificial defect was produced at one of 12 different locations on the outer surface of the elbow of each aluminum alloy piping specimen. The defect signals were observed as the defect depth was gradually increased at each defect location to obtain the defect sensitivity. The transmitted guided wave frequency was in turn set to 30 kHz, 40 kHz, and 50 kHz. At 30 kHz, high sensitivity values were obtained at the intrados of the elbows, whereas at 40 kHz and 50 kHz, high sensitivity values were obtained at their extrados. This paper also shows the results of computer simulations that used the same configuration as that used in the experiments to analyze the propagation behavior of guided waves passing through the elbow. In addition to the experimental results, the simulation results indicate that the defect-sensitive locations are controlled by the guided wave frequency. Thus, proper selection of the excitation frequency for guided wave testing enables efficient defect detection at pipe elbows.
収録刊行物
-
- MATERIALS TRANSACTIONS
-
MATERIALS TRANSACTIONS 57 (3), 397-403, 2016
公益社団法人 日本金属学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204254594688
-
- NII論文ID
- 130005678929
- 130005127319
-
- NII書誌ID
- AN00187860
-
- ISSN
- 13475320
- 18806880
- 24337501
- 13459678
- 00214876
-
- Web Site
- http://id.ndl.go.jp/bib/028305746
- https://ndlsearch.ndl.go.jp/books/R000000004-I028305746
- http://id.ndl.go.jp/bib/027195101
- https://ndlsearch.ndl.go.jp/books/R000000004-I027195101
- https://www.jstage.jst.go.jp/article/matertrans/57/3/57_M2015319/_pdf
- https://www.jstage.jst.go.jp/article/jinstmet/81/6/81_J2017002/_pdf
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDLサーチ
- Crossref
- CiNii Articles
- KAKEN
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可