Flow Injection Spectrophotometric Determination of Tetracycline in a Pharmaceutical Preparation by Complexation with Aluminium(III)

書誌事項

タイトル別名
  • Flow Injection Spectrophotometric Determination of Tetracycline in a Pharmaceutical Preparation by Complexation with Aluminium 3

この論文をさがす

抄録

A rapid flow injection (FI) spectrophotometric procedure for tetracycline determination is described. It is based on the injection of a 100 µl sample solution containing tetracycline into merged streams of aluminium(III) chloride (0.01 mol l-1) and Tris-buffer in the presence of KCl (0.06 mol l-1), pH 7.0, with the same optimum flow rate of 3.2 ml min-1. A yellow Al(III)-tetracycline complex was monitored at 376 nm. The flow injection system and the experimental conditions were optimized by means of the univariate method. The procedure was applied to the determination of tetracycline in pharmaceutical preparations with a high sampling rate of at least 165 h-1. A high precision with a relative standard deviation was obtained less than 0.72 and 0.30% of 5.0 and 10 µg ml-1 (n = 11), respectively. The detection limit (3 σ) and the quantification limit (10 σ) were 0.07 and 0.72 mg l-1, respectively. There were no interference effects from traditional excipients in the dosage forms when the method was applied to pharmaceutical preparations. The matrix effect could be reduced by the standard addition method.

収録刊行物

  • Analytical Sciences

    Analytical Sciences 22 (1), 15-19, 2006

    社団法人 日本分析化学会

被引用文献 (1)*注記

もっと見る

参考文献 (68)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ