書誌事項
- タイトル別名
-
- Reducing the required Power for the Screw Type Threshing Mechanism (Part 3)-Specifications of the Threshing Cylinder for Reducing the Torque.
- ギジュツ ロンブン スクリュケイ ダッコク キコウ ノ ダッコク サヨウ ニ ツイテ ダイ3ポウ ダッコクブ トルク オ テイゲン サセル コギ ドウ ノ シヨウ
- Specifications of the Threshing Cylinder for Reducing the Torque
- 脱穀部トルクを低減させるこぎ胴の仕様
この論文をさがす
抄録
5 divided areas of the threshing cylinder were made and the threshing torque and threshing performance where the cylinder had various specifications in every each area were predicted by comparison with the standard specification from the result of the indoor test. Several combinations of cylinder specifications were selected where the torque was less consumed within the allowable threshing loss. These specifications have a point in common where the threshing teeth are decreased in the front part of cylinder and the load in this part is made to reduce. And the threshing torque was to reduce more in case that the screw height gradually increased from top to end of the cylinder. The cylinders which had selected by calculation were tested in practical harvesting with the normal range of speed for the actual proof.
収録刊行物
-
- 農業機械学会誌
-
農業機械学会誌 62 (3), 121-127, 2000
農業食料工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204312028544
-
- NII論文ID
- 10013000586
-
- NII書誌ID
- AN00200470
-
- ISSN
- 18846025
- 02852543
-
- NDL書誌ID
- 5385060
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
