書誌事項
- タイトル別名
-
- Diameter and Number Density of Micro-Bubbles Generated by a Pressurized Dissolution Method
- カアツ ヨウカイホウ ニ ヨリ セイセイ シタ ビサイ キホウ ノ キホウケイ スウ ミツド
この論文をさがす
抄録
Effects of liquid volumetric flux JL and flow pattern in a decompression nozzle on the mean diameter and number density of micro-bubbles generated by using a pressurized dissolution method are experimentally investigated. The bubble diameter and number density are measured by using a phase Doppler anemometry at the exit of the decompression nozzle. The flow pattern in the decompression nozzle was observed by using a high speed camera. The experimental results indicate that the diameter and number density strongly depends on the flow pattern in the decompression nozzle, and their characteristics are classified into three regimes: (1) few bubbles are generated when no cavitation occurs, (2) when bubble cavitation takes place, the mean bubble diameter keeps low values which do not depend on JL so much and the bubble number density increases with JL, and (3) the mean bubble diameter increases with JL whereas the number density does not depend on JL when flow pattern in the nozzle is sheet cavitation.
収録刊行物
-
- 混相流
-
混相流 24 (4), 462-469, 2010
日本混相流学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204436554240
-
- NII論文ID
- 10028049527
-
- NII書誌ID
- AN10088286
-
- ISSN
- 18815790
- 09142843
-
- NDL書誌ID
- 10949313
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可