３点曲げＥＮＦ試験による木材のモードＩＩのき裂進展開始時の破壊じん性値の測定におけるき裂長さの影響

DOI Web Site Web Site 被引用文献7件 参考文献24件 オープンアクセス

書誌事項

タイトル別名
  • Influence of Crack Length on the Measurement of Mode II Initiation Fracture Toughness of Wood by Three-Point Bend End-Notched Flexure (3ENF) Test
  • 3テン マゲ ENF シケン ニ ヨル モクザイ ノ モード 2 ノ キレツ シンテン カイシジ ノ ハカイジンセイチ ノ ソクテイ ニ オケル キレツ ナガサ ノ エイキョウ

この論文をさがす

説明

The mode II initiation fracture toughness of wood was measured by the three-point bend end-notched flexure (3ENF) test for various crack lengths, and the dependence of toughness on the crack length was analyzed by the four conventional methods of data reduction : elementary beam theory, Williams end correction method, and two compliance calibration methods. In addition to these methods, the compliance combination method was used in which the fracture toughness is determined using the load-longitudinal strain compliance measured at the midspan as well as the loading-line compliance. In the four conventional data reduction methods, the dependence of aracture toughness on the crack length was significant. In contrast, the fracture toughness was appropriately determined by the compliance combination method, and it was independent of the crack length. Therefore, the compliance combination method is advantageous in that the fracture toughness is determined accurately by the 3ENF test alone without requiring separate tests over a wide range of crack length.

収録刊行物

被引用文献 (7)*注記

もっと見る

参考文献 (24)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ