放射光を用いた窒化アルミニウム‐銅積層膜の熱応力とその場測定

  • 日下 一也
    徳島大学大学院ソシオテクノサイエンス研究部
  • 英 崇夫
    徳島大学大学院ソシオテクノサイエンス研究部
  • 金子 健太
    徳島大学大学院先端技術科学教育部 [現 : 三菱電機 (株)]
  • 松英 達也
    新居浜工業高等専門学校環境材料工学科
  • 坂田 修身
    高輝度光科学研究センター

書誌事項

タイトル別名
  • In-situ Thermal Stress Measurement in Multi-layered Aluminum Nitride and Copper Films by Synchrotron Radiation
  • ホウシャコウ オ モチイタ チッカ アルミニウム ドウ セキソウマク ノ ネツ オウリョク ソノバ ソクテイ

この論文をさがす

説明

The specimen prepared in this study was multi-later aluminum nitride and copper films deposited on thermal oxidation silicon by dc sputtering. Thermal stresses in the copper layers were investigated by ultra high X-rays of synchrotron radiation in the heating and cooling process. It found from the sin2 ψ diagrams of the multi-layered film that the copper layers consisted of crystal grains which had two different orientations. One was randomly orientation, and the other was {111} orientation. The FWHM of the diffraction from the {111} -oriented crystal grains was constant regardless of heating temperature. On the other hand, the FWHM of the diffraction from the randomly-oriented crystal grains was decreased with increasing heating temperature at 1st heating cycle and it became constant regardless of heating temperature after the 1st heating cycle. The 2θ-sin2 ψ diagrams of the multi-layered film for the stress measurement showed non-linear. We could obtain thermal stresses in two different orientation crystal grains from the non-linear 2θ-sin2 ψdiagram at same time. For both crystal grains, the thermal stress differences between the 1st heating and the 1st cooling cycles were shown as a hysteresis loop. In the case of the 2nd thermal cycles, the thermal stresses changed linearly for both crystal grains. For the 1st heating cycle, the compressive thermal stress in the {111} -oriented crystal grains was larger than that in the randomly-oriented one.

収録刊行物

参考文献 (9)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ