Study of Coal Gasification Using High Ash Fusion Temperature Coal in an Entrained Flow Gasifier
-
- Kobayashi Nobusuke
- Department of Mechanical Engineering, Gifu University
-
- Fujimori Akina
- Department of Chemical Engineering, Nagoya University
-
- Tanaka Miku
- Department of Chemical Engineering, Nagoya University
-
- Piao Guilin
- School of Energy and Mechanical Engineering, Nanjing Normal University
-
- Itaya Yoshinori
- Department of Mechanical Engineering, Gifu University
この論文をさがす
抄録
In conventional entrained coal gasification, coal ash is usually discharged from the bottom as molten slag. Therefore, comparatively low ash fusion temperature coal is preferred. However, high ash fusion temperature coal contributes 30% of total world coal production, so a new gasification process has been proposed. We conducted a dry ash removal gasification experiment in an entrained down-flow gasifier using different ash fusion temperature coal. We measured gasification temperature and composition and volume of produced gas to evaluate the gasification behavior. Recovered ash was analysed to evaluate ash behavior. The performance and trend among gasification conditions were similar regardless of coal type, but ash behavior significantly varied depending on ash fusion temperature. Even when gasification temperature was similar, fly ash predominated if high ash fusion temperature coal was used, but ash adhered to the entrained gasifier wall as fouling when low ash fusion temperature coal was used.
収録刊行物
-
- JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
-
JOURNAL OF CHEMICAL ENGINEERING OF JAPAN 48 (1), 22-28, 2015
公益社団法人 化学工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204567367424
-
- NII論文ID
- 130004862036
-
- NII書誌ID
- AA00709658
-
- ISSN
- 18811299
- 00219592
-
- NDL書誌ID
- 026286469
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可