Fluid and Solids Flow Affecting the Solids Circulation Rate in Spouted Beds with a Draft-Tube

DOI Web Site Web Site 参考文献9件
  • Hattori Hirotsugu
    Department of Fine Materials Engineering, Faculty of Textile Science and Technology, Shinshu University
  • Ito Shinya
    Department of Fine Materials Engineering, Faculty of Textile Science and Technology, Shinshu University
  • Onezawa Tomomi
    Department of Fine Materials Engineering, Faculty of Textile Science and Technology, Shinshu University
  • Yamada Kazutaka
    Department of Fine Materials Engineering, Faculty of Textile Science and Technology, Shinshu University
  • Yanai Shinichi
    Department of Fine Materials Engineering, Faculty of Textile Science and Technology, Shinshu University

この論文をさがす

抄録

In a spouted bed, the gas flow rates cannot be changed independently in either the spout or the annulus. In this study, an experimental spouted bed equipped with a draft-tube was made in such a way that each of the gas flow rates can be changed independently. The effect of the gas flow rate in the spout or in the annulus on the circulation rate of solids was examined for the three types of spouted bed. The relation between the solids circulation rate and the average gas velocity in the annulus differs among these three types of spouted beds. In the spouted bed with a gas inlet nozzle, the solids circulation rate initially sharply decreased with the average gas velocity in the annulus. It was found that an eddy motion of solid particles caused this sharp decrease in the solids circulation rate. The fluid flow that caused this eddy motion in the solids was confirmed by using a two-dimensional water flow model.

収録刊行物

参考文献 (9)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ