Centrifuge Model Tests of Nailed Soil Slopes.

DOI NDLデジタルコレクション Web Site Web Site Web Site 被引用文献1件 参考文献42件

書誌事項

タイトル別名
  • Centrifuge Model Tests of Nailed Soil S

この論文をさがす

抄録

This paper presents the results of 24 centrifuge model tests of nailed soil slopes and vertical walls, constructed out of dry Leighton buzzard sand. The walls were initially supported by fluid pressure from flexible rubber bags against the face, and excavation was modelled by gradually draining the fluid from the bags. The finished model walls were 200 mm high and were initially tested at 30 g acceleration to correspond to a prototype structure 6.0 m high. If failure was not obtained, the acceleration was increased progressively to a maximum of 80 g. No surcharges were applied. The main parameters varied in the tests were the wall slope, nail length, nail surface roughness, nail inclination, facing stiffness and facing roughness. Observations were made of the mechanism of failure when it occurred, of soil pressures on the facing, and of pre-failure deformations. Failure was always by pull-out rather than breakage of the nails, and a series of pull-out tests of the model nails was conducted to aid interpretation of the results. Failure surfaces were seen to have the shape of logarithmic spirals, and limit equilibrium analyses based on these surfaces agreed well with experimental observations. Prior to failure, earth pressures on the facing compared reasonably well with those calculated by Coulomb's method, except at the base of the wall. One test set out to model a full-scale trial wall, and although the construction process could not be exactly modelled in the small-scale centrifuge tests, comparisons were sufficiently good to give confidence in the model test results.

収録刊行物

被引用文献 (1)*注記

もっと見る

参考文献 (42)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ