係数図法による2慣性共振系制御器の設計

DOI Web Site Web Site 被引用文献32件 参考文献21件 オープンアクセス

書誌事項

タイトル別名
  • Controller Design of Two-Mass Resonant System by Coefficient Diagram Method
  • ケイスウ ズホウ ニヨル 2 カンセイ キョウシンケイ セイギョキ ノ セッケ

この論文をさがす

説明

In the controller design of position or velocity control, the flexibility of the mechanical system is always the limiting factor to the higher performance. In this paper, the speed control of a two-mass resonant system, where the speed sensor is located only on the drive motor side, is investigated. Such a system is typically found in steel mill drives. The controller design is made successfully in practical sense using various design techniques, such as classical control, resonance ratio control with disturbance observer, and H∞ control. However, a unified theoretical approach is needed to understand the real nature of the problem. For this purpose, a new controller design approach, called “Coefficient Diagram Method”, is introduced. The result shows that the optimum controller, in normalized form, is the sole function of the ratio of motor inertia to the total inertia. As the ratio increases, the controller type needed varies from PI control to PI control with lag, and finally to PID control with lag where D control is week positive feedback. The typical controller designed in the past have been compared with this design.

収録刊行物

被引用文献 (32)*注記

もっと見る

参考文献 (21)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ