Temperatures of Positively and Negatively Stretched Flames.
-
- YAMAMOTO Kazuhiro
- Department of Mechanical Engineering, Faculty of Engineering Toyohashi University of Technology
-
- ISHIZUKA Satoru
- Department of Mechanical Engineering, Faculty of Engineering, Hiroshima University
この論文をさがす
説明
Both tubular flame temperature and Bunsen flame temperature have been measured for lean methane, hydrogen and propane/air mixtures. These temperatures have been compared with the adiabatic flame temperature, which is the typical temperature with no stretch. Results show that, the temperature of the tubular flame is almost the same as the adiabatic flame temperature for a lean methane/air mixture, considerably higher for a lean hydrogen/air mixture, and lower for a lean propane/air mixture. For the temperature around the Bunsen flame tip, this response is opposite to that of the tubular flame. To examine radiation effect, numerical simulation has been conducted. It is found that the radiative heat loss only reduces the flame temperature by 30 to 80°C. Thus, the different dependency of flame temperature on the mixtures is explained by stretch effect with the Lewis number considerations, and the response of these flames exhibits opposite behavior.
収録刊行物
-
- JSME International Journal Series B Fluids and Thermal Engineering
-
JSME International Journal Series B Fluids and Thermal Engineering 46 (1), 198-205, 2003
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204675705856
-
- NII論文ID
- 110003479146
-
- NII書誌ID
- AA10888815
-
- COI
- 1:CAS:528:DC%2BD3sXjtVKru70%3D
-
- ISSN
- 13475371
- 13408054
-
- HANDLE
- 2237/9370
-
- NDL書誌ID
- 6447038
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- IRDB
- NDLサーチ
- Crossref
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可