Fluid Flow and Local Heat Transfer around Two Cubes Arranged in Tandem on a Flat Plate Turbulent Boundary Layer
-
- NAKAMURA Hajime
- Department of Mechanical Engineering, National Defense Academy
-
- IGARASHI Tamotsu
- Department of Mechanical Engineering, National Defense Academy
-
- TSUTSUI Takayuki
- Department of Mechanical Engineering, National Defense Academy
この論文をさがす
抄録
Experimental studies were performed to investigate the fluid flow and local heat transfer around two cubes arranged in tandem on a flat plate turbulent boundary layer. The Reynolds number, based on the cube height d, ranged from 4.0×103 to 3.2×104. The thickness of the turbulent boundary layer δ was δ/d≤2.17. The surface temperature distribution around the cubes was measured with thermocouples under conditions of constant heat flux. The effect of spacing b between two cubes was clarified in the range of 0.33≤b/d≤1.33. In the case of b/d≥0.67, the horseshoe vortex is formed in front of each cube. However, at b/d=0.33, it does not form in front of the 2nd cube. The local heat transfer is high in the horseshoe vortex regions and the flow reattaching regions. The average Nusselt numbers of 1st cube, ¯Nu, and 2nd cube, ¯Nu, are expressed as ¯Nu=0.24Re0.66 and ¯Nu=0.27Re0.64, respectively. They are virtually unaffected by the spacing. However, that of base plate between two cubes, ¯Nu, has a maximum value of ¯Nu=0.47Re0.60 at about b/d=0.67.
収録刊行物
-
- JSME International Journal Series B Fluids and Thermal Engineering
-
JSME International Journal Series B Fluids and Thermal Engineering 44 (4), 584-591, 2001
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204676549120
-
- NII論文ID
- 110003474288
-
- NII書誌ID
- AA10888815
-
- ISSN
- 13475371
- 13408054
-
- NDL書誌ID
- 5978564
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可