The Airborne 1,3-Butadiene Concentrations in Rubber and Plastic Processing Plants

Bibliographic Information

Other Title
  • ゴムおよびプラスチック加工事業所における空気中1,3-ブタジエン濃度
  • 調査報告 ゴムおよびプラスティック加工事業所における空気中1,3-ブタジエン濃度
  • チョウサ ホウコク ゴム オヨビ プラスティック カコウ ジギョウショ ニ オケル クウキ チュウ 1 3 ブタジエン ノウド

Search this article

Description

Environment pollution by 1,3-butadiene had considerably increased in Japan. The main cause of the pollution is the automotive exhaust gas, and leaks from factories, smoking, and burning of rubber and plastic products are considered to be minor sources. The object of this study was to determine the contamination levels of airborne 1,3-butadiene in factories processing rubber and plastics containing 1,3-butadiene. The concentrations of airborne 1,3-butadiene were measured in 21 plants (10 rubber processing plants and 11 plastics processing plants) in Osaka. 1,3-Butadiene in air was collected for 10 minutes with a charcoal tube and a portable small pump adjusted to a 250 ml/min flow rate. In each plant, indoor air samples at five points and an outdoor air sample at one point outside the plant were collected. The samples were subjected to gas chromatography / mass spectrometry after thermal desorption from the charcoal. The concentrations of airborne 1,3-butadiene in the rubber processing plants and the plastics processing plants were 0.14-2.20 μg/m^3 mean: 0.48 μg/m^3 and 0.23-4.51 μg/m^3 mean: 0.80 μg/m^3 respectively. In all plants examined, indoor 1,3-butadiene concentrations were higher than the outdoor concentrations around the plants. Therefore, 1,3-butadiene was considered to arise from the processing of rubber or plastics, but the indoor 1,3-butadiene concentrations were much lower than the PEL-TWA (1 ppm = 2.21 mg/m^3) of OSHA and the TLV-TWA (2 ppm) of ACGIH. The concentrations in the plants with closed room conditions without ventilation were higher than the concentrations in the other plants. It was suggested that ventilation affected the 1,3- butadiene concentration in the plants.

Journal

References(32)*help

See more

Details 詳細情報について

Report a problem

Back to top