【4/18更新】CiNii ArticlesのCiNii Researchへの統合について

Surface Properties of Electrochemically Buffed Titanium Casting

  • OKAWA Seigo
    Division of Dental Biomaterial Science, Niigata University Graduate School of Medical and Dental Sciences
  • HOSSAIN Awlad
    Division of Dental Biomaterial Science, Niigata University Graduate School of Medical and Dental Sciences
  • KANATANI Mitsugu
    Division of Dental Biomaterial Science, Niigata University Graduate School of Medical and Dental Sciences
  • WATANABE Kouichi
    Division of Dental Biomaterial Science, Niigata University Graduate School of Medical and Dental Sciences
  • MIYAKAWA Osamu
    Division of Dental Biomaterial Science, Niigata University Graduate School of Medical and Dental Sciences

この論文をさがす

抄録

Electrochemical buffing, a combined process of electrochemical and mechanical polishing, was applied to titanium casting. Mixture of α-Al2O3 suspension (average grain diameter of 5μm) and 5% KNO3 solution was used as abrasive slurry. Specimen and experimental wheel buff were respectively connected to the positive and negative poles of a DC source, whose potential ratings ranged from 0V (MEP) to 10V (ECB10). Surface roughness, hardness, color, and cleanness were investigated. ECB10 surface produced a gold color and attained a mirror finish, as its roughness value was only one-quarter that of MEP. High amount of aluminum was present in MEP surface. Its bond state entirely differed from that of α-Al2O3, hence indicating surface alteration due to chemical reactions with the abrasive material. At higher potentials, reaction products might be dissolved anodically, so that the surface was chemically clean to some extent. The surface also became rich in OH-.

収録刊行物

被引用文献 (5)*注記

もっと見る

参考文献 (30)*注記

もっと見る

関連論文

もっと見る

関連研究データ

もっと見る

関連図書・雑誌

もっと見る

関連博士論文

もっと見る

関連プロジェクト

もっと見る

関連その他成果物

もっと見る

詳細情報

問題の指摘

ページトップへ