3次元アークモデルの開先部への適用

書誌事項

タイトル別名
  • Numerical Analysis of Arc Plasma Behavior in Groove Welding with 3D TIG Arc Model

抄録

Arc welding phenomena have been theoretically investigated by using various numerical models, which have been proposed and developed together with rapid progress of the computer technologies. However, most of the numerical models are two-dimensional axial symmetric model that are available only for stationary arc on the flat plate. Actual welding processes applied to manufacturing field are performed with various joint geometries and the welding arc moves on the base metal. Therefore, they should be non-axial symmetric phenomena and it is required to be discussed with three-dimensional model. In this research, TIG arc characteristics in V-groove welding are numerically investigated by using our three-dimensional numerical model. It is shown that both of heat input and arc pressure on the groove surface are significantly different from the flat plate surface. In the groove heat input and arc pressure are varied sensitively with location and aiming of the TIG torch. Experimental results show the validity of calculation results of TIG arc heat input distribution on the groove surface.

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (4)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1390001204725553408
  • NII論文ID
    130004445631
  • DOI
    10.2207/qjjws.28.10
  • ISSN
    24348252
    02884771
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ