水中研磨過程でのTa/Zr界面の水素脆化割れ現象と水素脆化機構  ‐SUS304ULC/Ta/Zr爆発接合継手の水素脆化に関する研究‐

書誌事項

タイトル別名
  • Behaviour and Mechanism of Hydrogen Embrittlement Cracking at Ta/Zr Bond Interface during Underwater Polishing Process - Hydrogen Embrittlement in SUS304ULC/Ta/Zr Explosive Bonded Joint -
  • Behaviour and Mechanism of Hydrogen Embrittlement Cracking at Ta/Zr Bond Interface during Underwater Polishing Process
  • - Hydrogen Embrittlement in SUS304ULC/Ta/Zr Explosive Bonded Joint -
  • -SUS304ULC/Ta/Zr爆発接合継手の水素脆化に関する研究-

この論文をさがす

抄録

Hydrogen embrittlement cracking behaviours of SUS304/Ta/Zr explosive bonded joint during underwater polishing were investigated. Hydrogen embrittlement cracks occurred in the Zr substrate adjacent to the Ta/Zr bond interface during underwater polishing. The open circuit potential of Zr during underwater polishing was drastically reduced immediately after mechanical polishing (within a fraction of a second). The hydrogen yields of Zr-Ta alloys and cold-worked Zr during underwater polishing were estimated from the corrosion current determined by the Tafel extrapolation method. The hydrogen yield increased with a decrease in the Ta content of Zr-Ta alloy, and with an increase in the degree of working (rolling reduction) of Zr. It was deduced that the mechanical grinding in water removing the passive oxide film on the Zr substrate led to the hydrogen absorption into the Zr substrate and the precipitation of zirconium hydrides. Accordingly, hydrogen embrittlement cracks occurred in the deformation layer of Zr around the Ta/Zr bond interface due to the tensile residual stress in the explosive bonded joint.

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (22)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1390001204726468224
  • NII論文ID
    10030150051
  • NII書誌ID
    AN1005067X
  • DOI
    10.2207/qjjws.28.230
  • ISSN
    24348252
    02884771
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ