Evaluation of Machinability of Ceramics in Grinding, Honing and Superfinishing.
-
- UEDA Takashi
- 正会員金沢大学工学部
-
- SUGITA Tadaaki
- 正会員金沢大学工学部
Bibliographic Information
- Other Title
-
- ファインセラミックスの研削・ホーニング・超仕上における被削性の統一的評価
- ファイン セラミックス ノ ケンサク ホーニング チョウ シアゲ ニ オケル
Search this article
Abstract
The functions to evaluate the machinability of ceramics in grinding, honing and superfinishing are derived theoretically, assuming that one stone (wheel) corresponds to a single point tool with a long cutting edge. The dimensional analysis is employed to investigate the effect of physical properties of the ceramic material on its machinability. Work materials used in experiments are Al2O3, SiC, Si3N4, ZrO2 which are sintered under atmospheric pressure, Mn-Zn ferrite and SiO2. The main results are as follows. The machinability of the ceramic material depends on not only its physical properties but also the method of machining. For the work materials of Al2O3 and SiO2, the honing is superior in cutting ability to the grinding. In grinding and superfinishing the strong relation is observed between the energy release rate of the ceramic and its machinability, but in honing it is observed between the hardness of the ceramic and its machinability.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 59 (4), 680-686, 1993
The Japan Society for Precision Engineering
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390001204763791744
-
- NII Article ID
- 110001371354
- 120005478643
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL BIB ID
- 3822521
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed