-
- SAKAMOTO Masafumi
- 正会員 九州工業大学
-
- NAKAMURA Taira
- 正会員 九州工業大学
-
- MOTOYOSHI Satoshi
- 日産自動車 (株)
Bibliographic Information
- Other Title
-
- 高速フライス削りに関する基礎的研究
- コウソク フライス ケズリ ニ カンスル キソテキ ケンキュウ カーバイドケイ
- Wear of Oxide Tools
- カーバイド系セラミック工具の損傷
Search this article
Abstract
The plain type milling test with oxide tools added carbide has been performed on 0.53%, carbon steel at high cutting speed range. The wear patterns and the wear rates are measured together and the application of oxide tools in the plain type milling at high speed range are investigated. The important results obtained are as follows.<BR>(1) The tool life of oxide tools are superior to carbide tools at high cutting speed range. (2) The wear rates of plain type milling cutters at high cutting speed range are ruled by the flank wear of tools.<BR>(3) The flank wear rate curves with cutting speed consist of two parts.<BR>(4) In first part, the small honeycomb pattern cracks appear in the flank face a little away from the cutting edge of the tools. The small honeycomb pattern cracks grow up gradually and then the end of cracks reach the cutting edge of tools, they begin to trans-form the small groove wear. This part is called the second part of tool wear.<BR>(5) In spite of the wear rates in the second part of wear are influenced by the number of impact cycle and the temperature of cutting edge, the distractive tool failure does not occur at all.
Journal
-
- Journal of the Japan Society of Precision Engineering
-
Journal of the Japan Society of Precision Engineering 45 (537), 1082-1087, 1979
The Japan Society for Precision Engineering
- Tweet
Details 詳細情報について
-
- CRID
- 1390001204764061824
-
- NII Article ID
- 110001290714
- 130003961538
-
- NII Book ID
- AN00130014
-
- NDL BIB ID
- 2063358
-
- ISSN
- 03743543
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed