書誌事項
- タイトル別名
-
- In-process Measurement of Wear of Grinding Wheel by Using Hydrodynamic Pressure in Wet Grinding Condition. (1st Report). Measurement Principle.
- ドウアツ オ リヨウ シタ シッシキ ケンサク ニ オケル トイシ マモウ ノ インプロセス ソクテイ ダイ1ポウ ソクテイ ゲンリ
- Measurement Principle
- 測定原理
この論文をさがす
抄録
In order to realize precision grinding, in-process measurement of grinding wheel wear is required. No method for the inprocess measurement of the wear of a grinding wheel with high accuracy in wet condition has been studied because grinding fluid causes a difficulty in measurement. In this paper, a measurement method by hydrodynamic pressure around the grinding wheel caused by grinding fluid is proposed for measuring the wear amount of a grinding wheel. A pressure sensor is set around a grinding wheel. The grinding fluid is supplied to the gap between the grinding wheel and the sensor. Because the viscous fluid is dragged into the clearance between a grinding wheel and a pressure sensor, the hydrodynamic pressure is generated. The relation among hydrodynamic pressure, gap distance and rotational frequency is examined. With the increase in gap distance between the sensor and the disk, the hydrodynamic pressure decreases. By using the measured hydrodynamic pressure, the distance between the sensor in the gap and the grinding wheel can be calculated so that the grinding wheel wear can be measured. The maximum error in using grinding wheels is less than 2 μm in dispersion. By calibrating the relation between hydrodynamic pressure and a gap distance, the measurement can be made towards the actual grinding wheel.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 66 (1), 127-131, 2000
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001204765130112
-
- NII論文ID
- 110001372760
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 4955675
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
