焼入鋼のエンドミル加工に関する研究 (第1報)  切削抵抗の簡易推定式とそれを用いた切削抵抗の一定化制御

書誌事項

タイトル別名
  • A Study on Endmilling of Hardened Steel. (1st Report). Simplified Prediction Model for Cutting Forces and Control for Constant Cutting Foces Using this Model.
  • ヤキイレ コウ ノ エンドミル カコウ ニ カンスル ケンキュウ ダイ1ポウ セッサク テイコウ ノ カンイ スイテイシキ ト ソレ オ モチイタ セッサク テイコウ ノ イッテイカ セイギョ
  • Simplified Prediction Model for Cutting Forces and Control for Constant Cutting Forces Using this Model
  • 切削抵抗の簡易推定式とそれを用いた切削抵抗の一定化制御

この論文をさがす

抄録

This paper deals. with the mathematical model for cutting forces by (A1, Ti)N-coated micro-grain carbide radius endmill cutter during endmilling of hardened steel used for dies and molds. A quadratic polynomial model was proposed for cutting forces based on response surface methodology by two variables of the engagement angle of cutting tool and the maximum undeformed chip thickness. In endmilling of hardened steel, the control of cutting forces is especially important because chipping occurs soon if severe cutting forces are present at the cutting edge. The control of cutting forces in profile endmilling which includes both straight and comer cutting, was very effective using this model. Furthermore, response surface form was applied for the case of wom endmill that had a cutting edge with large negative rake angle, and it was found that the control of cutting forces was also possible with some compensation even for the worn tool.

収録刊行物

  • 精密工学会誌

    精密工学会誌 66 (5), 730-734, 2000

    公益社団法人 精密工学会

被引用文献 (9)*注記

もっと見る

参考文献 (8)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ