書誌事項
- タイトル別名
-
- Electrocontact Discharge Dressing of Metal-Bonded Diamond Grinding Wheel Utilizing a Hybrid Electrode.
- ハイブリッド デンキョク オ モチイタ メタルボンドダイヤモンドホイール ノ セッショク ホウデン ドレッシング
この論文をさがす
抄録
A hybrid rotary electrode has been developed as a means to realize a precision electrocontact discharge (ECD) dressing of the bronze-bonded diamond grinding wheel. The hybrid electrode consists of paired electrode blades whose gaps are filled with GC abrasive grains to prevent the electric discharge from concentration without an excessively eroded part, and the removal of resolidified bond material to be piled up on the bond matrix is also expected. From the experiments using two electrodes, the hybrid one and a pure electrode without GC abrasives, it has been clarified that the truing effect due to ECD is produced at the DC voltage higher than 20 V in the both methods; however, the hybrid method has an ability to generate a closer wheel surface topography than that obtained from pure ECD method and a finished roughness better than that obtained from the mechanical method using a GC cup truer is achieved if a DC voltage lower than 40 V is applied. The wear of the grinding wheel after hybrid ECDD is the same as that after pure ECDD, but no increase in power due to undesirable contact of the metal bond with the workpiece is observed.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 65 (11), 1628-1632, 1999
公益社団法人 精密工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204765884928
-
- NII論文ID
- 110001372567
- 10007198740
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 4988892
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可