書誌事項
- タイトル別名
-
- Finishing of Hob Tooth Flank by Plunge Grinding
- プランジ ケンサク ニ ヨル ホブ ノ ニゲ メン シアゲ
この論文をさがす
抄録
It is desirable to increase the number of cutting edges per bob revolution as much as possible to reduce the burden of each cutting edge and the polygon error caused in bobbing process. But, it is difficult to increase the number of cutting edges because interference between the grinding wheel and the following cutting edge in relief grinding of the hob is apt to occur. A method for finishing the hob cutting edges by plunge grinding without relieving motion is proposed. In the method, the cutting edge is finished when the grinding wheel and hob work are in a static position. In this paper, the calculation method of the grinding wheel profile to finish the cutting edges, the optimum static position to obtain the desirable clearance angle, and the effects of the positioning errors of the grinding wheel on the accuracy of finished cutting edges are investigated.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 69 (11), 1615-1619, 2003
公益社団法人 精密工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204796130944
-
- NII論文ID
- 110001368364
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL書誌ID
- 6756128
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可